CONSTRUCTA washing machine Instruction Manual download pdf (Page 5)

E-5

ElInstallation instructions

Removing transit bolts

Location of washer

• Check location where the washer will be installed. Make sure you have everything necessary for correct

installation.

• Do not place or store your washer below 0°C (32°F) to avoid any damage from freezing.

• Do not place or store laundry products on top of washer at any times

• Install the washer on the horizontal solid floor.

If the washer is installed on an unsuitable floor, it could make

considerable noise, vibrate severely and cause a malfunction. If the

washer is not level, adjust leg up or down for horizontal installation.

• Ventilation openings must not be obstructed by carpeting when the

washer is installed on a carpeted floor.

• Leave some space (right & left : 2cm, rear : 10cm).

• In case of built-in installation, the distance between top of the washer and

bottom of upper plate should be at least 3mm.

1. Before operating the washer, remove the transit

bolts(4ea) along with the rubber.

• If the bolts are not removed, it may cause

heavy vibration, noise and malfunction.

2. Unscrew the 4 bolts with the 10mm hex wrench

or spanner or cross-tip screwdriver. Keep the 4

bolts for a later time.

• When the appliance is transported, transit bolts

will be re-used.

3. Close the holes with the cap holders supplied.

Laundry

Tub

Washer

approx.

2cm

Drain Hose

1 2 3 4 5 6 7 8 9 10 ... 31 32

No comments

CONSTRUCTA washing machine Instruction Manual Page 5